Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Resources Infor ERP Tips & News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

Subscribe to newsletter

Kathy Barthelt
/ Categories: Infor LN & Baan Tips, Integrations & Enhancements, Consulting, Finance, Manufacturing, Operations, Technology

Infor LN & Baan Tip: Financial Integration Mapping Scheme

Transactions to be mapped - In the mapping scheme, you must define the ledger mapping and the dimension mapping for these types of transactions:

  1. Financial integration transactions resulting from logistic events in Operations Management.
  2. General Ledger transactions.
  3. Procurement card transactions in Accounts Payable.


In addition, to support dimension accounting you must define the dimension mapping of financial transactions from Accounts Payable and from Invoicing to the various dimensions.

The setup procedure - creating, changing, or extending an integration mapping scheme, consists of these steps:

  1. Map scheme prerequisites.
  2. If no mapping scheme exists, create a mapping scheme.
  3. Create a mapping scheme version.
  4. Map by Reconciliation Group (tfgld4166m000)
  5. Set up the integration transaction document numbers for the integration transactions.
  6. Set up compression of the transactions.
  7. Check and activate a mapping scheme for your mapping scheme version.

Previous Article Infor LX & BPCS Tip: Main Benefits of IDF?
Next Article Infor LX & BPCS | Infor LN & Baan: Accuracy & Productivity Aren't Important!
Print
59305 Rate this article:
5.0
Kathy Barthelt

Kathy BartheltKathy Barthelt

Other posts by Kathy Barthelt
Contact author

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

You can see the status of the Shop Order when using SFC300 Shop Order Inquiry. You want to be sure that your shop orders are at the correct status in order to report against them.

The following are the shop order status codes:

04 = The Shop order has been entered.

05 = The Shop order has been released and printed.

14 = The Shop order has been released, but not printed. If a shop order is at this status, you have released it and it is not printed due to a system failure, or the order has been put on hold.

XX = The Shop order is closed.

Read more
For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
Read more
FirstLast

Tips: LN | Baan

Categories