Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Resources Infor ERP Tips & News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

Subscribe to newsletter

Kathy Barthelt
/ Categories: Infor LN & Baan Tips, Finance

Infor LN & Baan Tips & Tricks for FINANCE: Remap Posted Integration Transactions (tfgld4282m100)

Use this session to remap Posted transactions that were mapped incorrectly.

To remap integration transactions successfully, several conditions must be fulfilled. For details, refer to To remap integration transactions.

Enter the ranges of selection criteria for the integration transaction or range of integration transactions to be remapped. You can select the integration transactions of a range of business objects or of a specific business object.

You must select a specific integration document type or an integration document type group.

To evaluate the remapping before you perform the actual remapping, you can select the Simulate check box and the Error Report check box. After you solve the errors, you can run the session again and clear the Simulate check box.

After remapping the integration transactions, you can use the Post Integration Transactions (tfgld4282m000) session to create the postings in the General Ledger.

Previous Article Elevate Your Team's Output with Expert LN & Baan Help Desk Services
Next Article Infor LN & Baan Tips & Tricks for OPERATIONS: Using Country of Origin for Purchase Orders
Print
45963 Rate this article:
5.0
Kathy Barthelt

Kathy BartheltKathy Barthelt

Other posts by Kathy Barthelt
Contact author

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

You can see the status of the Shop Order when using SFC300 Shop Order Inquiry. You want to be sure that your shop orders are at the correct status in order to report against them.

The following are the shop order status codes:

04 = The Shop order has been entered.

05 = The Shop order has been released and printed.

14 = The Shop order has been released, but not printed. If a shop order is at this status, you have released it and it is not printed due to a system failure, or the order has been put on hold.

XX = The Shop order is closed.

Read more
For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
Read more
FirstLast

Tips: LN | Baan

Categories