Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Resources Infor ERP Tips & News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

Subscribe to newsletter

George Moroses
/ Categories: Infor LX & BPCS Tips

Infor LX & BPCS Tip: Infor LX & BPCS Cycle Counting Selection Process

The cycle counting sub-system in Inventory Management determines which items are selected for cycle counting based on the following criteria:

  1. Cycle Counts/Year: The system calculates the cycle count frequency for each item using the "Cycle Counts/Year" field in the Item Master file (optional).

  2. Last Cycle Count Date: If you use locations, this date is found in the Location Inventory file (ILI), and if you don't, it's in the Warehouse Inventory file (IWI).

The system adds the calculated cycle count frequency to the last cycle count date. If the result is less than or equal to today's date, the item is selected for cycle counting. If it's greater, the item is not due for cycle counting yet.

Additionally, an item is automatically selected for cycle counting if the Cycle Flag field in the ILI/IWI record contains 'Y.' This flag indicates that the item's on-hand balance has gone negative since the last cycle count, even if it's not negative at the time of selection. The programs INV500D, INV510, and BIL540 can set this flag.

You can further narrow down the selection of items by specifying item number or warehouse limits.

Previous Article "Apologies, boss, but at the moment, we are unable to contribute to advancing the business."
Next Article Infor LX & BPCS Tip: How to handle “ZERO COST” items
Print
23143 Rate this article:
5.0
George Moroses

George MorosesGeorge Moroses

Other posts by George Moroses
Contact author

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

You can see the status of the Shop Order when using SFC300 Shop Order Inquiry. You want to be sure that your shop orders are at the correct status in order to report against them.

The following are the shop order status codes:

04 = The Shop order has been entered.

05 = The Shop order has been released and printed.

14 = The Shop order has been released, but not printed. If a shop order is at this status, you have released it and it is not printed due to a system failure, or the order has been put on hold.

XX = The Shop order is closed.

Read more
For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
Read more
FirstLast

Tips: LN | Baan

Categories