Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

Crossroads RMC

Effective September 30, 2023, IBM® will end support of the IBM i operating system 7.3

AND Infor will no longer support LX and related products on IBM i 7.3 as of June 1, 2024

THE CLOCK is T I C K I N G ... 

MARK YOUR CALENDARS!
Effective September 30, 2023, IBM® will end support of the IBM i operating system 7.3  AND  in line with IBM’s support policy, Infor will no longer support LX and related products on IBM i 7.3 after May 31, 2024.

All Infor LX releases, patches, and related solutions will be delivered and compiled at IBM i 7.4, effective June 1, 2024. 
These deliverables will install and function on version 7 release 4 (IBM i 7.4) and above (IBM announced in May 2023 the release of V7R5M0).
NOTE: This will require your operating system to be at a minimum release level of IBM i 7.4.

This policy extends to other Infor LX-related technologies including:

  • WebTop
  • System iWorkspace (SiW)
  • Infor Development Framework (IDF)


ACTION  STEPS

We recommend you start planning your upgrade to IBM i 7.4 (*or above) to allow ample time for testing and completion prior to June 1, 2024. It is strongly recommended that you keep current to avoid these extra fees.
*Special NOTE:  All versions of LX 8.3.4 and below will see an annual 20% Extended Maintenance Fee.

Please reach out to Crossroads RMC to assist you in this planning and execution process. We have assisted many other clients with both IBM OS and Infor ERPLX software upgrades. 

800.762.2077 |  solutions@crossroadsrmc.com

Previous Article Infor LN & Baan Tip: Considerations for Release to Warehousing for a Cost Item
Next Article ERP & the Importance of Accuracy & Productivity
Print
13872 Rate this article:
5.0
Crossroads RMC

Crossroads RMCCrossroads RMC

Other posts by Crossroads RMC

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

You can see the status of the Shop Order when using SFC300 Shop Order Inquiry. You want to be sure that your shop orders are at the correct status in order to report against them.

The following are the shop order status codes:

04 = The Shop order has been entered.

05 = The Shop order has been released and printed.

14 = The Shop order has been released, but not printed. If a shop order is at this status, you have released it and it is not printed due to a system failure, or the order has been put on hold.

XX = The Shop order is closed.

For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
FirstLast

Tips: LN | Baan

Categories