Please Wait a Moment
X

Infor LX Tips, Infor LN Tips, BPCS Tips, Baan Tips, Infor M3 Tips & Infor ERP News

Crossroads Connections

Infor ERP Tips & News from the Experts

Infor LX | Infor LN | BPCS | Baan | Infor M3

George Moroses
/ Categories: Infor LX & BPCS Tips

Infor LX & BPCS Tip: Configurable Ledger (CLD) Benefits

Did you know CLD provides you with the following benefits?

▪ You can journalize and post-transaction data from any third-party application or Infor LX subsystem to the Configurable Ledger (CLD).

▪ You can generate multiple journal entries across different charts of accounts, ledgers, and books within the CLD from one transaction line.

▪ You can automatically post transaction amounts across different books using an appropriate exchange rate between the batch transaction currency and target book currency.

▪ You can use validation reports to identify validation errors within the files that contain batch transaction data and then you can make any necessary corrections before resubmission.

▪ You can use standard CEA grouping and summarization options for journals created during Batch Transaction Processing.

▪ You can interface GLD journal entries into CEA for the BPCD version of Infor LX. This allows data to be interfaced into CEA without changing the way data is processed through Infor LX subsystems.

Previous Article Digital Transformation & Your ERP
Next Article Infor Moves IBM i Products to New 'Compass' Group
Print
29554 Rate this article:
5.0
George Moroses

George MorosesGeorge Moroses

Other posts by George Moroses

Contact author

Please solve captcha
x

Tips:  LX | BPCS | M3

You can see the status of the Shop Order when using SFC300 Shop Order Inquiry. You want to be sure that your shop orders are at the correct status in order to report against them.

The following are the shop order status codes:

04 = The Shop order has been entered.

05 = The Shop order has been released and printed.

14 = The Shop order has been released, but not printed. If a shop order is at this status, you have released it and it is not printed due to a system failure, or the order has been put on hold.

XX = The Shop order is closed.

For either file, you must specify a valid location code as defined in the Location Master File.

If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations.

Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine.

In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used.
FirstLast

Tips: LN | Baan

Categories