Anthony Etzel / Thursday, October 30, 2014 / Categories: Infor LX & BPCS Tips BPCS/LX Tip of the Week: Work Center & Machine Locations For either file, you must specify a valid location code as defined in the Location Master File. If the machine master locations are blank, then the work center locations are used. There are cases where you may want to do a combination between the two in defining the locations. Let’s say the end item has one operation. The operation is at work center 510 and Machine A is in the work center. You have locations setup in both the Work center file and the Machine master File. You report 100 complete at the work center without specifying the machine. In this case, the inventory will be processed based on the locations defined in the work center file. If the transaction included the machine number, then the locations in the machine file would be used. Previous Article Baan/LN Tip of the Week: What could go wrong with GRINYA? Next Article BPCS/LX Tip of the Week: Shop Order Status Print 74196 Rate this article: 4.0 Anthony EtzelAnthony Etzel Other posts by Anthony Etzel Contact author Facebook page Twitter Linked In YouTube Website Leave a comment Name: Please enter a name. Email: Please enter an email address. Please enter a valid email address. Comment: Please enter comment. I agree This form collects your name, email, IP address and content so that we can keep track of the comments placed on the website. For more info check our Privacy Policy and Terms Of Use where you will get more info on where, how and why we store your data. You must read and accept this rules. Add comment